Aquaflo Series 9 Bath Filler

Fitting instructions for the Aquaflo Series 9 Bath Filler

Bath Shower Mixer/Filler

Prior to installation please check that your plumbing system is adequate and that all pipes have been sufficiently flushed through.

1. Turn off mains water supply. The mains stopcock is usually found where the supply enters the building.

2. We also recommend that any water heating systems be turned off.

3. Drain the hot and cold water systems. To ensure complete drainage, open all taps.

4. To install position the tap ensuring that the washer is between the fixing nut and the bath, then tighten the fixing nut.

DO NOT OVER TIGHTEN.

5. Connection to the water supply is usually achieved using existing 22m pipe work and connections, although flexible tap connectors can be used if needed.

PLEASE NOTE:

To comply with water regulations, isolating valves should be fitted in the pipework beneath the mixer. This enables eash supply to be independently isolated which makes it easier to service and or remove the mixer.

6. Once all the connections are made, the mains water supply can be turned back on and the system refilled. Now check for any leaks. At this stage it is recommended that the whole system be flushed to remove and foreign matter, also check the seating is free from swart, as this will interfere with the water seal between the valve and the seating.

All the water heating systems may now be turned on.